Intercom Master Station
CP 100S Intercom Main Station front view

CP 100S Intercom Main Station rear view



Datasheet
Catalog
CP-100S Main Station
with two wire principle for full duplex operation with headsets

The new half 19 inch main station CP100S uses the two wire principle or party line principle for full duplex operation with headsets and has a built in monitoring loudspeaker.

All headsets with dynamic microphone cartridges may be used with the station. Gooseneck microphones or wired microphones may be plugged into the 3 pin xlr connector on the units’ front.

A line termination switch on the back facilitates a stable intercom level. To be switched on when CP100S is being used as a master station. When powered from another station, the switch should not be activated.

The external power supply allows universal operation (100 – 240 V) of approximately 10 components such as belt packs or signal lights.

The CP100S may be mounted in a 19” rack via an optional rack kit RMK100.

Specifications
External power supply 24 VDC, 1 A secondary, 100-240 VAC primary provides sufficient power for approximately 10 intercom components
Dimensions 20 x 12 x 4.4 cm (W x D x H)
Weight 785 g net without power supply

Technical data subject to change without notice